Introduction

Use this guide to replace the brush in the head of the vacuum.

Place the vacuum on its back. On the bottom right side, push the red lever to the left.
  • Place the vacuum on its back.

  • On the bottom right side, push the red lever to the left.

  • Remove the plastic cover.

Ajouter un commentaire

Grab the red switch under the brush and push left. Then remove the plastic base plate. Then remove the plastic base plate.
  • Grab the red switch under the brush and push left.

  • Then remove the plastic base plate.

Ajouter un commentaire

Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush. Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush. Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.
  • Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.

Ajouter un commentaire

Remove the two screws on the left side of the brush. Remove the two screws on the left side of the brush. Remove the two screws on the left side of the brush.
  • Remove the two screws on the left side of the brush.

Ajouter un commentaire

Pull the clear plastic away from the head of the vacuum. Slide the belt off the metal rod with your finger. Pull the brush free.
  • Pull the clear plastic away from the head of the vacuum.

  • Slide the belt off the metal rod with your finger.

  • Pull the brush free.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Erik Ingels

Membre depuis le 18/01/2018

193 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team S12-G4, Banghart Winter 2018 Membre de l'équipe Cal Poly, Team S12-G4, Banghart Winter 2018

CPSU-BANGHART-W18S12G4

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 40