Introduction

All of the internal surfaces, especially the conductive metal pieces, need to be clean and well kept in order for the microphone to function at its best.

Pièces

Aucune pièce nécessaire.

Grab the microphone base with one hand. With the other hand, grab just below the grille (the collar). Twist the collar clockwise to loosen it. Be careful to not pull on the collar or you may rip the wires from the faceplate. Be careful to not pull on the collar or you may rip the wires from the faceplate.
  • Grab the microphone base with one hand. With the other hand, grab just below the grille (the collar). Twist the collar clockwise to loosen it.

  • Be careful to not pull on the collar or you may rip the wires from the faceplate.

Ajouter un commentaire

Create a mild cleaning solution by mixing a few drops of dish soap and water in a cup.
  • Create a mild cleaning solution by mixing a few drops of dish soap and water in a cup.

  • Using a detailing brush and the solution, gently brush the pins and inside walls of the microphone.

Ajouter un commentaire

Make sure connector is completely dry before soldering, failure to do so may result in permanent damage.
  • Make sure connector is completely dry before soldering, failure to do so may result in permanent damage.

  • If you have previously soldered inside the microphone, you may use a soldering iron to melt off any excess solder that may be on the pins inside the connector. Do not attempt this if you have never soldered on the microphone before.

Ajouter un commentaire

Conclusion

After cleaning the faceplate and reassembling the microphone, it should work at its maximum potential.

nat coll

Membre depuis le 27/09/2012

366 Réputation

17 tutoriels rédigés

Équipe

Cal Poly, Team 7-53, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 membres

18 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 13

30 derniers jours : 73

Total : 5,548