Introduction

Use this guide to replace the charging port in your Huawei Mate 10 Pro smartphone.

Switch off your phone. Remove the SIM card tray. Use an iOpener to loosen the adhesive beneath the back cover.
  • Switch off your phone.

  • Remove the SIM card tray.

  • Use an iOpener to loosen the adhesive beneath the back cover.

Ajouter un commentaire

Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger. Use the halberd spudger to cut the adhesive beneath the display on all sides of the phone. Use opening picks to avoid the adhesive from sticking to the back cover again while cutting the adhesive on all sides.
  • Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.

  • Use the halberd spudger to cut the adhesive beneath the display on all sides of the phone.

    • Use opening picks to avoid the adhesive from sticking to the back cover again while cutting the adhesive on all sides.

Ajouter un commentaire

Don't remove the back cover all the way, yet. The fingerprint sensor cable is still connected to motherboard. Flip the back cover over to the side.
  • Don't remove the back cover all the way, yet. The fingerprint sensor cable is still connected to motherboard.

  • Flip the back cover over to the side.

  • Remove the Phillips #00 screw which holds down the metal shield, sitting on top of the connection of the fingerprint sensor cable.

Ajouter un commentaire

Use tweezers to remove the metal shield covering the connector of the fingerprint sensor. Disconnect the fingerprint sensor cable with a spudger.
  • Use tweezers to remove the metal shield covering the connector of the fingerprint sensor.

  • Disconnect the fingerprint sensor cable with a spudger.

  • When reassembling your phone apply new adhesive where it is necessary.

Ajouter un commentaire

Remove the 12 Phillips #00 screws. Carefully remove the shields on top of the motherboard and the charging board. In case the shields do not pop out easily on their own after you removed the Phillips screws, you can use the pointed end of a spudger to pry them out.
  • Remove the 12 Phillips #00 screws.

  • Carefully remove the shields on top of the motherboard and the charging board.

    • In case the shields do not pop out easily on their own after you removed the Phillips screws, you can use the pointed end of a spudger to pry them out.

Ajouter un commentaire

Use a spudger to disconnect the charging port flex cable from the motherboard and the daughterboard. Use a spudger to disconnect the charging port flex cable from the motherboard and the daughterboard.
  • Use a spudger to disconnect the charging port flex cable from the motherboard and the daughterboard.

Ajouter un commentaire

Carefully remove the charging port including its flex cable with tweezers. The charging port sits tightly in its recess. In case you have trouble removing it, use the flat end of a halberd spudger to pry it out.
  • Carefully remove the charging port including its flex cable with tweezers.

    • The charging port sits tightly in its recess. In case you have trouble removing it, use the flat end of a halberd spudger to pry it out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Dominik Schnabelrauch

Membre depuis le 23/11/2016

12 858 Réputation

247 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

114 membres

5 894 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 30

30 derniers jours : 104

Total : 126