Introduction

The Insignia 2-in-1 Handheld vacuum button may get jammed or the electrical components can stop working. In either case, this guide can show you how to fix or replace the power button.

Pièces

Aucune pièce nécessaire.

Push down the black button to release the dust cup. Pull the dust cup up and away from handheld portion to remove.
  • Push down the black button to release the dust cup.

  • Pull the dust cup up and away from handheld portion to remove.

Ajouter un commentaire

Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.
  • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

  • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

Ajouter un commentaire

Pull apart the red and black wires. Do so for all of the wires. (Red x1, Black x2)
  • Pull apart the red and black wires.

  • Do so for all of the wires. (Red x1, Black x2)

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Remove the tape holding the battery to the black housing.
  • Remove the tape holding the battery to the black housing.

  • Slide the entire battery bundle out.

Ajouter un commentaire

Remove motor and impeller housing to gain access to power button.
  • Remove motor and impeller housing to gain access to power button.

Ajouter un commentaire

Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector. Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.
  • Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.

Ajouter un commentaire

Remove the two 10mm  Philips #2 screws holding the brown printed circuit board to the vacuum. Remove brown printed circuit board.
  • Remove the two 10mm Philips #2 screws holding the brown printed circuit board to the vacuum.

  • Remove brown printed circuit board.

  • Pull up on clear plastic power button assembly to remove.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Membre depuis le 15/02/2018

421 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S16-G3, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S16-G3, Boczar Spring 2018

USFT-BOCZAR-S18S16G3

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 8

Total : 61