Introduction

The Insignia 2-in-1 stick vacuum power button can suddenly stop working or become jammed. In either case, use this guide to fix or replace the power button.

Pièces

Aucune pièce nécessaire.

Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle. Pull up on the back cover of the vacuum handle and remove it. Pull up on the back cover of the vacuum handle and remove it.
  • Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle.

  • Pull up on the back cover of the vacuum handle and remove it.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Remove the two 10mm Phillips #2  screws on the back of the green printed circuit board. If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection. If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.
  • Remove the two 10mm Phillips #2 screws on the back of the green printed circuit board.

  • If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Membre depuis le 15/02/2018

421 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S16-G3, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S16-G3, Boczar Spring 2018

USFT-BOCZAR-S18S16G3

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 35