Introduction

This guide shows you how to replace the spring on the power button.

Pièces

Aucune pièce nécessaire.

Turn the device upside down so that the three rubber pads are facing up.
  • Turn the device upside down so that the three rubber pads are facing up.

Ajouter un commentaire

Use a heat gun (set to low) to apply heat  to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.
  • Use a heat gun (set to low) to apply heat to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.

Ajouter un commentaire

Remove the heated rubber pad with a plastic opening tool.
  • Remove the heated rubber pad with a plastic opening tool.

  • Repeat steps 2 and 3 for the two remaining rubber pads.

Ajouter un commentaire

Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver. Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.
  • Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.

Ajouter un commentaire

Open the device along its seam. Be careful when separating the device because there are wires connecting the two seperate halves. Be careful when separating the device because there are wires connecting the two seperate halves.
  • Open the device along its seam.

  • Be careful when separating the device because there are wires connecting the two seperate halves.

Ajouter un commentaire

Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.
  • Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.

Ajouter un commentaire

Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device. Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.
  • Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.

Where do I find these speakers

HighChief - Réponse

Pull the plastic button off the post. Pull the plastic button off the post.
  • Pull the plastic button off the post.

Ajouter un commentaire

Remove the metal U-clip (compressing the spring) with tweezers.
  • Remove the metal U-clip (compressing the spring) with tweezers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Janessa D Cabrera

Membre depuis le 23/01/2014

478 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 9-28, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 9-28, Maness Winter 2014

CPSU-MANESS-W14S9G28

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 9

30 derniers jours : 25

Total : 1,258