Introduction

The front wheel of the JD Razor 2000 is located directly underneath the handlebar and T-Bar.

Pièces

Orient the scooter so that the front wheel is facing you. Observe the right and left side of the wheel. Remember which is which throughout the guide. Using an Allen wrench, unscrew the axle bolt slowly from the right side while applying a constant pressure with your hand on the left side of the bearing. If the left side of the bolt turns while you unscrew the right side, you will need to use a second Allen wrench to prevent it from moving
  • Orient the scooter so that the front wheel is facing you. Observe the right and left side of the wheel. Remember which is which throughout the guide.

  • Using an Allen wrench, unscrew the axle bolt slowly from the right side while applying a constant pressure with your hand on the left side of the bearing.

    • If the left side of the bolt turns while you unscrew the right side, you will need to use a second Allen wrench to prevent it from moving

    • If the bolt does not move at all, or moves very little, try applying a lubricant on as much of the screw as possible and try again in 5 minutes.

  • Carefully pull apart the bolt and bearing from either side of the wheel.

Ajouter un commentaire

Grip the bottom of the wheel and gently slide it out.
  • Grip the bottom of the wheel and gently slide it out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kaylan Naicker

Membre depuis le 14/10/2014

249 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 4-46, Amido Fall 2014 Membre de l'équipe Cal Poly, Team 4-46, Amido Fall 2014

CPSU-AMIDO-F14S4G46

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 7

Total : 313