Introduction

The T-Bar allows you to steer and control your scooter. This guide will show the replacement of a T-Bar.

Pièces

Aucune pièce nécessaire.

Unlock the quick-release lever by turning the lever from a tightened position. Unlock the quick-release lever by turning the lever from a tightened position.
  • Unlock the quick-release lever by turning the lever from a tightened position.

Ajouter un commentaire

Use a 7/32" Allen Wrench or T25 Screwdriver to loosen the screw shown. Be sure to fasten the opposite side of the screw before unscrewing. Remove the screw and note the order of the parts for reassembly.
  • Use a 7/32" Allen Wrench or T25 Screwdriver to loosen the screw shown.

  • Be sure to fasten the opposite side of the screw before unscrewing.

  • Remove the screw and note the order of the parts for reassembly.

Ajouter un commentaire

Turn the quick-release lever over to reveal an 8mm screw. Use the Phillips #2 screw driver to remove the screw. After removing the screw, the circular latch will be detachable.
  • Turn the quick-release lever over to reveal an 8mm screw.

  • Use the Phillips #2 screw driver to remove the screw.

  • After removing the screw, the circular latch will be detachable.

Ajouter un commentaire

After disassembling the Quick-Release Lever, the T-Bar is removable
  • After disassembling the Quick-Release Lever, the T-Bar is removable

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Shane

Membre depuis le 18/10/2014

358 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 4-46, Amido Fall 2014 Membre de l'équipe Cal Poly, Team 4-46, Amido Fall 2014

CPSU-AMIDO-F14S4G46

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 6

Total : 178