Introduction

There are a few layers that you have to work through to get to the inside of the Kid Galaxy Explorer. There are screws on the top and bottom holding the Kid Galaxy Explorer together so if it is not coming apart do not pry it open; check for more screws.

Pièces

Aucune pièce nécessaire.

First, completely loosen the 9.6 mm Phillips #2 screw on top. There is a plastic washer that holds the screw to the top cover, so it will not need to be taken out.
  • First, completely loosen the 9.6 mm Phillips #2 screw on top. There is a plastic washer that holds the screw to the top cover, so it will not need to be taken out.

Ajouter un commentaire

After the screw has been loosened, lift the cover off.
  • After the screw has been loosened, lift the cover off.

Ajouter un commentaire

Completely loosen the 9.6 mm Phillips #2 screw from the battery cover. Once again, there is a plastic washer to hold the screw to the cover.
  • Completely loosen the 9.6 mm Phillips #2 screw from the battery cover. Once again, there is a plastic washer to hold the screw to the cover.

Ajouter un commentaire

After the screw is loosened, lift the battery cover off the top cover to gain access to the batteries.
  • After the screw is loosened, lift the battery cover off the top cover to gain access to the batteries.

  • Turn the RC car over to reach the six screws on the bottom.

Ajouter un commentaire

Remove the six 11.6 mm Phillips #2 screws on the bottom cover.
  • Remove the six 11.6 mm Phillips #2 screws on the bottom cover.

  • (Wheels are removed in this picture to clearly show screw location. They do not need to be removed for this step)

Ajouter un commentaire

Lift the top Cover off the car.
  • Lift the top Cover off the car.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Studstrup

Membre depuis le 22/09/2014

4 Réputation

2 tutoriels rédigés

Équipe

USF Tampa, Team 1-2, Hickman Fall 2014 Membre de l'équipe USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 membres

7 tutoriels rédigés

As i can see in the last image. There are some wires still connected with the outer cover. Could have shown couple more images how to get them off. Everything else looks great.

Dishant Patel - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 103