Introduction

This guide will show you how to replace your Kurio's battery.

Make sure to open the back cover easily using the plastic opening tool.
  • Make sure to open the back cover easily using the plastic opening tool.

Ajouter un commentaire

Remove back cover by prying away from the device. The easiest place to remove the cover is from the bottom and top, then try to open it from the right and left sides. Open it gently. Do not open it with too much pressure, so that the plastic back cover do not break.
  • Remove back cover by prying away from the device.

  • The easiest place to remove the cover is from the bottom and top, then try to open it from the right and left sides.

  • Open it gently. Do not open it with too much pressure, so that the plastic back cover do not break.

Ajouter un commentaire

To remove the battery, make sure the four 5mm Philips screws on each side of your device is open using the Phillips #1 Screwdriver. To remove the battery, make sure the four 5mm Philips screws on each side of your device is open using the Phillips #1 Screwdriver. To remove the battery, make sure the four 5mm Philips screws on each side of your device is open using the Phillips #1 Screwdriver.
  • To remove the battery, make sure the four 5mm Philips screws on each side of your device is open using the Phillips #1 Screwdriver.

Ajouter un commentaire

After you remove your four screws use your plastic opening tool to help you open the plastic cover of your device.
  • After you remove your four screws use your plastic opening tool to help you open the plastic cover of your device.

Ajouter un commentaire

Use the plastic opening tool to remove the battery from its place.
  • Use the plastic opening tool to remove the battery from its place.

  • The battery is glued into the device. So try removing it gently.

Ajouter un commentaire

Remove the two wires using soldering tool to detach your bad battery from the device .
  • Remove the two wires using soldering tool to detach your bad battery from the device .

  • Gently remove the wires one by one. Do not damage the head that is glued into the motherboard.

  • For more information on how to solder and desolder the wire Click here

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Khalid AlTamimi

Membre depuis le 21/01/2015

251 Réputation

2 tutoriels rédigés

Équipe

USF Tampa, Team 6-5, Brown Winter 2015 Membre de l'équipe USF Tampa, Team 6-5, Brown Winter 2015

USFT-BROWN-W15S6G5

3 membres

5 tutoriels rédigés

do you know where to buy a replacement battery ?

Phil Bowring - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 15

Total : 1,172