Push the light gray rectangle in the top-center up. While pushing up grab the sides of the battery and pull out. While pushing up grab the sides of the battery and pull out.
  • Push the light gray rectangle in the top-center up.

  • While pushing up grab the sides of the battery and pull out.

Ajouter un commentaire

Unscrew the antenna by grasping the base and twisting counterclockwise.
  • Unscrew the antenna by grasping the base and twisting counterclockwise.

    • The antenna may separate from a black sleeve during removal. You may need to use tweezers to remove the sleeve. Remove both the antenna and the sleeve and set aside.

Ajouter un commentaire

The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside. The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.
  • The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.

Ajouter un commentaire

Using a Torx screwdriver with a T6-sized bit, unscrew the four screws on the back of the phone. The bit size is engraved on the base of the bit head.
  • Using a Torx screwdriver with a T6-sized bit, unscrew the four screws on the back of the phone.

    • The bit size is engraved on the base of the bit head.

Ajouter un commentaire

With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone. Gently pull the two pieces apart to separate. Apply enough force to separate the pieces without cracking the back cover.
  • With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone.

  • Gently pull the two pieces apart to separate.

    • Apply enough force to separate the pieces without cracking the back cover.

Ajouter un commentaire

Lift the computer chip to gain access to the keypad and side buttons beneath. CAUTION: The computer chip is attached with a thin ribbon wire at upper right corner of case. DO NOT BREAK THE RIBBON WIRE.
  • Lift the computer chip to gain access to the keypad and side buttons beneath.

    • CAUTION: The computer chip is attached with a thin ribbon wire at upper right corner of case. DO NOT BREAK THE RIBBON WIRE.

Ajouter un commentaire

Conclusion

<b>To reassemble your device, follow these instructions in reverse order.</b>

Nico Chiarito

Membre depuis le 21/01/2010

22 Réputation

8 tutoriels rédigés

Équipe

Cal Poly, Team 8-47, Regan Winter 2010 Membre de l'équipe Cal Poly, Team 8-47, Regan Winter 2010

CPSU-REGAN-W10S8G47

5 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 2,437