Remove speaker screens by working them lose with a plastic opening tool. You may need to first losen them with iFixit tweasers or a craft knife.
  • Remove speaker screens by working them lose with a plastic opening tool. You may need to first losen them with iFixit tweasers or a craft knife.

  • These screens are held in place by glue and are hard to remove. Take your time.

Ajouter un commentaire

Remove the 3.14" Philips screws from both spots that were covered.
  • Remove the 3.14" Philips screws from both spots that were covered.

Ajouter un commentaire

Go all around the casing prying the screen away from the backing with a spudger.
  • Go all around the casing prying the screen away from the backing with a spudger.

  • It will make a popping sound each time one of the lock tabs is disconnected.

  • DO NOT USE A METAL TOOL FOR THIS.

  • Take your time as you move all around the device prying the backing off.

Ajouter un commentaire

Pull off the plastic covering the battery cable.
  • Pull off the plastic covering the battery cable.

Ajouter un commentaire

Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers. Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers.
  • Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers.

Ajouter un commentaire

Remove the battery by grabbing the tab shown and pulling up.
  • Remove the battery by grabbing the tab shown and pulling up.

  • The battery is held to the device by a bit of adhesive. Just pull the battery up from the tab and it will lift out with a bit effort.

Ajouter un commentaire

The speakers are connected to the tablet by glue and require a lot of prying to remove. Make sure to get all the way under the speakers when prying. Make sure to get all the way under the speakers when prying.
  • The speakers are connected to the tablet by glue and require a lot of prying to remove.

  • Make sure to get all the way under the speakers when prying.

Ajouter un commentaire

This step is not necessary if you aren't replacing the speakers. To the remove the wires heat the solder connecting the wires to the board, and gently pull on the wires.
  • This step is not necessary if you aren't replacing the speakers.

  • To the remove the wires heat the solder connecting the wires to the board, and gently pull on the wires.

  • Remember the placement of the red and black wires.

  • Connect new speakers by soldering the wires onto the board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Josiah Speed

Membre depuis le 22/09/2014

900 Réputation

4 tutoriels rédigés

Équipe

USF Tampa, Team 10-4, Brown Fall 2014 Membre de l'équipe USF Tampa, Team 10-4, Brown Fall 2014

USFT-BROWN-F14S10G4

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 4

Total : 463