Introduction

This guide will show how to replace the guitar's battery pack. The battery pack supplies power to the controller and houses the two AA batteries required for the controller.

Outils

Aucun outil requis.

Pièces

Aucune pièce nécessaire.

Remove batteries
  • Remove batteries

Ajouter un commentaire

Remove void warranty sticker The sticker is covering a torx screw
  • Remove void warranty sticker

    • The sticker is covering a torx screw

Ajouter un commentaire

Unscrew the 11 screws securing the back of the body using a T10 Torx screwdriver. Each screw is 1 cm long. Push level, this will detach the back of the guitar from the front. Carefully remove the back of the body
  • Unscrew the 11 screws securing the back of the body using a T10 Torx screwdriver. Each screw is 1 cm long.

  • Push level, this will detach the back of the guitar from the front.

  • Carefully remove the back of the body

    • The battery pack cord is attached to both sides of the guitar, be careful not to tear it apart.

    • The neck connector may be stuck to the back so be sure to detach it before fully pulling

Ajouter un commentaire

Gently move the capacitor around until it breaks off Gently move the capacitor around until it breaks off
  • Gently move the capacitor around until it breaks off

Ajouter un commentaire

Solder on the new capacitor.
  • Solder on the new capacitor.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Chris

Membre depuis le 18/10/2013

737 Réputation

6 tutoriels rédigés

Yo can you help for the drum set I saw two wires detached ( red an black) when I I opened it up. Please email me so I can send a picture djcab361@outlook.com

Chris - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 32

30 derniers jours : 97

Total : 3,931