Introduction

Is your disco ball not sending out groovy beams of light anymore? The most common problem is the light bulb is burnt out. This guide will teach you how to replace that light bulb, so you can get back to partying!

Pièces

Aucune pièce nécessaire.

Unplug the device to avoid injury.
  • Unplug the device to avoid injury.

  • Turn the device over, so that the base is on top.

Ajouter un commentaire

Compress the tab by pushing towards the center of the device with a spudger. While compressing the tab, peel the base away from the rotating head. While compressing the tab, peel the base away from the rotating head.
  • Compress the tab by pushing towards the center of the device with a spudger.

  • While compressing the tab, peel the base away from the rotating head.

Ajouter un commentaire

If the metal brackets come off of the sphere, put them back on the plastic piece as shown in the photo.
  • If the metal brackets come off of the sphere, put them back on the plastic piece as shown in the photo.

Ajouter un commentaire

Unscrew the burnt-out light bulb with a counter-clockwise twist. Do not apply too much pressure when unscrewing light bulb, as the light bulb may break.
  • Unscrew the burnt-out light bulb with a counter-clockwise twist.

  • Do not apply too much pressure when unscrewing light bulb, as the light bulb may break.

Ajouter un commentaire

Ligne d'arrivée

3 autre(s) ont terminé cette réparation.

Nick Kaprielian

Membre depuis le 14/01/2014

495 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 17-3, Forte Winter 2014 Membre de l'équipe Cal Poly, Team 17-3, Forte Winter 2014

CPSU-FORTE-W14S17G3

5 membres

7 tutoriels rédigés

Great! Wasn't sure how to remove the base. Thank you!

derigo1957 - Réponse

Saved me a headache. Couldn't figure out how to remove base. Thanks!

mccullough1251 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 4

7 derniers jours : 26

30 derniers jours : 106

Total : 6,113