Introduction

Regain the function of your speakers by replacing the audio board.

Remove the following 10 screws securing the lower case to the Air:
  • Remove the following 10 screws securing the lower case to the Air:

    • Six 2.8 mm Phillips screws.

    • Two 3.8 mm Phillips screws.

    • Two 5.4 mm Phillips screws.

Ajouter un commentaire

Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs. Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.
  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

Ajouter un commentaire

Disconnect the battery connector by pulling it straight out of its socket.
  • Disconnect the battery connector by pulling it straight out of its socket.

Ajouter un commentaire

Remove the following nine screws securing the battery to the Air:
  • Remove the following nine screws securing the battery to the Air:

    • Four 2.9 mm Phillips.

    • Four 3.8 mm Phillips.

    • One 7.2 mm Phillips.

Ajouter un commentaire

Free Shipping on all orders 79,00 $US and up.

Parcourez notre boutique
MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Lift the battery out of the Air.
  • Lift the battery out of the Air.

Ajouter un commentaire

Remove the following two screws securing the speaker assembly to the upper case.
  • Remove the following two screws securing the speaker assembly to the upper case.

    • One 3 mm Phillips.

    • One 5.8 mm Phillips.

Ajouter un commentaire

Use a spudger to lift the audio-out connector board off the adhesive that secures it to the hard drive bracket. Disconnect the audio out connector from its socket.
  • Use a spudger to lift the audio-out connector board off the adhesive that secures it to the hard drive bracket.

  • Disconnect the audio out connector from its socket.

Ajouter un commentaire

Rotate the speaker assembly toward the center of the Air. Use a spudger to pry the speaker cable connector up off the audio board.
  • Rotate the speaker assembly toward the center of the Air.

  • Use a spudger to pry the speaker cable connector up off the audio board.

Ajouter un commentaire

Use the pointed end of a spudger to pry the speaker connector up off the audio board.
  • Use the pointed end of a spudger to pry the speaker connector up off the audio board.

Ajouter un commentaire

Insert the pointed end of a spudger into the gap around the audio board to pry it up off the adhesive securing it to the speaker housing.
  • Insert the pointed end of a spudger into the gap around the audio board to pry it up off the adhesive securing it to the speaker housing.

Ajouter un commentaire

Disconnect the audio out cable by pulling its connector straight away from the socket on the audio board.
  • Disconnect the audio out cable by pulling its connector straight away from the socket on the audio board.

Ajouter un commentaire

Audio board remains.
  • Audio board remains.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

9 autre(s) ont terminé cette réparation.

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 14

30 derniers jours : 72

Total : 19,299