Introduction
This detects the internal temperature of your machine for heat management.
Ce dont vous avez besoin
-
-
Use your fingers to push both battery release tabs away from the battery, and lift the battery out of the computer.
-
-
-
Remove the two 2.8 mm Phillips screws in the battery compartment near the latch.
-
-
-
-
Disconnect the right fan cable from the logic board by placing a spudger beneath the cable and lifting up.
-
-
-
Disconnect the right thermal sensor cable from the logic board by placing a spudger beneath the cable and lifting up.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.