Introduction

Use this as a guide to remove the motherboard so you can access the FightPad's buttons and directional pad.

Use tweezers to completely remove the sticker from the rear of controller.
  • Use tweezers to completely remove the sticker from the rear of controller.

Ajouter un commentaire

Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
  • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

Ajouter un commentaire

Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases. Use the plastic opening tool to pry the two cases apart.
  • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

  • Use the plastic opening tool to pry the two cases apart.

Ajouter un commentaire

Remove the two rubber side grips. Remove the two rubber side grips.
  • Remove the two rubber side grips.

Ajouter un commentaire

Locate RS-DP-LS switch. Pull upwards on the switch to remove it.
  • Locate RS-DP-LS switch.

  • Pull upwards on the switch to remove it.

Ajouter un commentaire

Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
  • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

Ajouter un commentaire

Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board. Be careful with the wires connected to the circuit board itself as they are thin and delicate. When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.
  • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

  • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

  • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jefferson Hsu

Membre depuis le 18/09/2012

408 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 1-7, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 8

Total : 1,617