Introduction

This guide will go through the steps of replacing the LCD screen for the Motorola MB525 starting from the tear down of the phone to replacement of the LCD screen itself.

Using the screwdriver and the T-5 bit, unscrew the seven 5 mm screws around the outside of the phone.
  • Using the screwdriver and the T-5 bit, unscrew the seven 5 mm screws around the outside of the phone.

Ajouter un commentaire

Remove the back cover of the phone by sliding the bottom black button to the unlock position and lifting it up. Remove the back cover of the phone by sliding the bottom black button to the unlock position and lifting it up.
  • Remove the back cover of the phone by sliding the bottom black button to the unlock position and lifting it up.

Ajouter un commentaire

Use a plastic opening tool to pry the battery out of the phone.
  • Use a plastic opening tool to pry the battery out of the phone.

Ajouter un commentaire

Unscrew the two silver screws located at the top of the back of the phone.
  • Unscrew the two silver screws located at the top of the back of the phone.

Ajouter un commentaire

Use a plastic opening tool to gently pry the midframe from the rest of the phone.
  • Use a plastic opening tool to gently pry the midframe from the rest of the phone.

Ajouter un commentaire

Use metal spudger to pry off the middle yellow flap carefully. Use metal spudger to pry off the middle yellow flap carefully.
  • Use metal spudger to pry off the middle yellow flap carefully.

Ajouter un commentaire

Use tweezers again to pry off the second yellow flap carefully. Use tweezers again to pry off the second yellow flap carefully. Use tweezers again to pry off the second yellow flap carefully.
  • Use tweezers again to pry off the second yellow flap carefully.

Ajouter un commentaire

The motherboard is the whole green board. Pry it off carefully with tweezers from the sides and place it aside.
  • The motherboard is the whole green board. Pry it off carefully with tweezers from the sides and place it aside.

Ajouter un commentaire

Stick the metal spudger in between the LCD screen and the case of the phone. Remove the LCD screen and replace with a new one.
  • Stick the metal spudger in between the LCD screen and the case of the phone.

  • Remove the LCD screen and replace with a new one.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Ebrahem AlRayes

Membre depuis le 08/10/2014

187 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team 14-2, Leahy Fall 2014 Membre de l'équipe USF Tampa, Team 14-2, Leahy Fall 2014

USFT-LEAHY-F14S14G2

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 707