Introduction

With a few simple steps, this guide shows you how to open your Moto G to get to the innards of your phone.

Pièces

Aucune pièce nécessaire.

You can remove the outer cover on the back of the phone by using a plastic opening tool. After removal the inner back cover will be exposed as shown. This part is moderately difficult, especially if you've never taken the outer back cover off before this point. It may take you several tries, but please be patient. The cover is surprisingly flexible, but not enough to withstand a lot of pressure.
  • You can remove the outer cover on the back of the phone by using a plastic opening tool. After removal the inner back cover will be exposed as shown.

  • This part is moderately difficult, especially if you've never taken the outer back cover off before this point.

  • It may take you several tries, but please be patient. The cover is surprisingly flexible, but not enough to withstand a lot of pressure.

Ajouter un commentaire

Shut down the phone.
  • Shut down the phone.

  • Push SIM card until it pops out.

  • Remove SIM card.

Ajouter un commentaire

Using a T5 Torx screwdriver head, take out the 14 screws (3.5 mm diameter and 5 mm long) that hold the back plate in place. Make sure to keep all of the screws together, as they are very easily lost. The magnetic project mat or a container is a great way to keep all the little metal screws as well as other small metal pieces from being lost.
  • Using a T5 Torx screwdriver head, take out the 14 screws (3.5 mm diameter and 5 mm long) that hold the back plate in place.

  • Make sure to keep all of the screws together, as they are very easily lost.

  • The magnetic project mat or a container is a great way to keep all the little metal screws as well as other small metal pieces from being lost.

Die Schrauben sind Torx T4!

Armin Jacob - Réponse

To confirm Armin’s comment - yes, the screws are T4 not T5.

Richard H - Réponse

Use the plastic opening tool to take out the inner back cover after all the screws have been removed. This will expose the motherboard and the attached battery. Take note that once inner back cover is removed the two buttons on the side can easily fall out or be removed.
  • Use the plastic opening tool to take out the inner back cover after all the screws have been removed.

  • This will expose the motherboard and the attached battery.

  • Take note that once inner back cover is removed the two buttons on the side can easily fall out or be removed.

It’s a good idea to make a note now of which way the buttons go back!

Richard H - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

8 autre(s) ont terminé cette réparation.

Rebecca Montgomery

Membre depuis le 25/09/2014

3 726 Réputation

12 tutoriels rédigés

Équipe

USF Tampa, Team 1-6, Brown Fall 2014 Membre de l'équipe USF Tampa, Team 1-6, Brown Fall 2014

USFT-BROWN-F14S1G6

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 31

Total : 2,685