Introduction
Use this repair guide to replace the back housing in a Motorola RAZR2 v9m.
Ce dont vous avez besoin
-
-
Push the rear cover toward the hinge of the RAZR2. The panel will slide about 3 mm.
-
-
-
-
Gently press the pointy end of the spudger into the edge of the bumper until it bows and separates from the phone.
-
Grab the bowed portion of bumper. Gently lift and peel the bumper away from the phone.
-
-
-
Remove the two 4-mm T5 Torx screws, previously hidden beneath the flip stop bumper pad.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.