Introduction

Replacing the power cord on the TF6 requires several wiring tools and previous experience with soldering. For soldering tips and directions, consult the guide on how to solder and desolder connections.

Facing the bottom of the TF6, carefully pull the two rubber feet out with your hands.
  • Facing the bottom of the TF6, carefully pull the two rubber feet out with your hands.

Ajouter un commentaire

Using a Phillips #1 screwdriver, remove the six 11mm Phillips screws that are holding the bottom cover in place. Using a Phillips #1 screwdriver, remove the six 11mm Phillips screws that are holding the bottom cover in place.
  • Using a Phillips #1 screwdriver, remove the six 11mm Phillips screws that are holding the bottom cover in place.

Ajouter un commentaire

Gently lift the bottom cover, detaching it from the main body of the TF6.
  • Gently lift the bottom cover, detaching it from the main body of the TF6.

Ajouter un commentaire

Using a Phillips #1 screwdriver, remove the two 13mm Phillips screws that are securing the wire harness.
  • Using a Phillips #1 screwdriver, remove the two 13mm Phillips screws that are securing the wire harness.

Ajouter un commentaire

Carefully lift the wire harness from the base of the TF6, detaching it completely.
  • Carefully lift the wire harness from the base of the TF6, detaching it completely.

  • The power cord wiring is now completely accessible.

Ajouter un commentaire

Using a set of wire cutters, cut both leads of the power cord at the heatshrinked area where the leads split. Using a set of wire cutters, cut both leads of the power cord at the heatshrinked area where the leads split.
  • Using a set of wire cutters, cut both leads of the power cord at the heatshrinked area where the leads split.

Ajouter un commentaire

Using your fingers, pry the heatshrink off from the power cord leads. Using your fingers, pry the heatshrink off from the power cord leads.
  • Using your fingers, pry the heatshrink off from the power cord leads.

Ajouter un commentaire

Using a 14-16 AWG wire stripper, strip the leads on the replacement power cord.
  • Using a 14-16 AWG wire stripper, strip the leads on the replacement power cord.

Ajouter un commentaire

Solder the power cord's positive lead to the white nylon wire.
  • Solder the power cord's positive lead to the white nylon wire.

  • Solder the power cord's ground lead to the bronze nylon wire.

  • Ensure the correct leads are being soldered together (power to power, ground to ground). Soldering the incorrect leads together will result in hazardous conditions for both the TF6 and the user when the unit is powered on.

    • Consult the replacement power cord's user manual, packaging, or manufacturer in order to verify the power and ground leads.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew

Membre depuis le 24/01/2014

101 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 13-18, Regan Winter 2014 Membre de l'équipe Cal Poly, Team 13-18, Regan Winter 2014

CPSU-REGAN-W14S13G18

4 membres

5 tutoriels rédigés

Good tutorial, I like this

Sfapa - Réponse

Excellent! very helpful...

NP Designs 123 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 525