Introduction

This guide will demonstrate how to remove the capacitors in order to replace them. Soldering and de-soldering will be required.

Turn the device so that the bottom is facing up.
  • Turn the device so that the bottom is facing up.

Ajouter un commentaire

Use the plastic opening tool to carefully lift the rubber stops in each corner. Do not completely remove the rubber stops, because they are difficult to replace. Do not completely remove the rubber stops, because they are difficult to replace.
  • Use the plastic opening tool to carefully lift the rubber stops in each corner.

  • Do not completely remove the rubber stops, because they are difficult to replace.

Ajouter un commentaire

Unscrew the 4 11.8 mm T-8 Torx screws from each corner of the device. Unscrew the 4 11.8 mm T-8 Torx screws from each corner of the device.
  • Unscrew the 4 11.8 mm T-8 Torx screws from each corner of the device.

Ajouter un commentaire

Lift the lower case straight up from the rest of the router. Lift the lower case straight up from the rest of the router.
  • Lift the lower case straight up from the rest of the router.

Ajouter un commentaire

Remove the clear plastic casing by lifting it straight up from the router. Remove the clear plastic casing by lifting it straight up from the router.
  • Remove the clear plastic casing by lifting it straight up from the router.

Ajouter un commentaire

Separate the motherboard from the top shell by lifting it straight up from the router. Separate the motherboard from the top shell by lifting it straight up from the router.
  • Separate the motherboard from the top shell by lifting it straight up from the router.

Ajouter un commentaire

Turn the motherboard so that the top is facing upwards.
  • Turn the motherboard so that the top is facing upwards.

  • Place the motherboard on a clean flat surface.

Ajouter un commentaire

Locate the four capacitors.
  • Locate the four capacitors.

Ajouter un commentaire

Turn the motherboard so that the bottom is facing upwards. Locate the two soldered contacts for each capacitor.
  • Turn the motherboard so that the bottom is facing upwards.

  • Locate the two soldered contacts for each capacitor.

Ajouter un commentaire

Do not refer to the pictures in this step for correct soldering and de-soldering techniques. They are solely for illustration purposes. Desolder the soldered connections between the capacitors and the motherboard, and pull the capacitor from the motherboard.
  • Do not refer to the pictures in this step for correct soldering and de-soldering techniques. They are solely for illustration purposes.

  • Desolder the soldered connections between the capacitors and the motherboard, and pull the capacitor from the motherboard.

  • For proper soldering and de-soldering techniques, refer here.

  • When reinstalling the capacitor, make sure the negative side of the capacitor is aligned with the shaded white region of the circle.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathon Sather

Membre depuis le 23/01/2013

27 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 3-31, Amido Winter 2013 Membre de l'équipe Cal Poly, Team 3-31, Amido Winter 2013

CPSU-AMIDO-W13S3G31

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 9

Total : 1,028