Introduction

This guide will show how to access the motherboard which will give you the ability to remove the lens and flash.

Pièces

Aucune pièce nécessaire.

Remove the two 2.8 mm screws on the left side of the camera.
  • Remove the two 2.8 mm screws on the left side of the camera.

Ajouter un commentaire

Remove the four 2.8 mm screws on the right side of the camera.
  • Remove the four 2.8 mm screws on the right side of the camera.

Ajouter un commentaire

Remove the three 4.1 mm screws on the bottom of the camera.
  • Remove the three 4.1 mm screws on the bottom of the camera.

Ajouter un commentaire

Gently lift the rear cover from the camera.
  • Gently lift the rear cover from the camera.

Ajouter un commentaire

Gently lift the screen out of its place.
  • Gently lift the screen out of its place.

  • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

Ajouter un commentaire

Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.
  • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

Ajouter un commentaire

Slowly pull the screen from the camera.
  • Slowly pull the screen from the camera.

Ajouter un commentaire

Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.
  • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

Ajouter un commentaire

Lift up silver LCD base plate
  • Lift up silver LCD base plate

Ajouter un commentaire

Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable. Slide the button panel ribbon cable out of its socket on the motherboard.
  • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

  • Slide the button panel ribbon cable out of its socket on the motherboard.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Shauna

Membre depuis le 05/04/2011

750 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 12-32, Maness Spring 2011 Membre de l'équipe Cal Poly, Team 12-32, Maness Spring 2011

CPSU-MANESS-S11S12G32

4 membres

5 tutoriels rédigés

It would be nice to have a guide for replacing the flash capacitor.

danwat1234 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 18

Total : 5,243