Introduction

Make sure your battery is fully charged and it's the correct model if you have purchased a new battery. The battery should be an EN-EL14a Rechargeable Li-ion Battery or EN-EL14 Rechargeable Li-ion Battery.

Locate the battery compartment on the bottom of the camera directly below the mode dial.
  • Locate the battery compartment on the bottom of the camera directly below the mode dial.

Ajouter un commentaire

Find the marked arrow on the battery compartment door and firmly push following the arrow's direction to release the latch.
  • Find the marked arrow on the battery compartment door and firmly push following the arrow's direction to release the latch.

I don't think its wise to install a battery when your going to be removing the control board as this could cause a short circuit and the board and or the battery could burn up, you should remove the battery prior to working on the internal parts of the camra

starstrip411 - Réponse

Release the latch and allow it to completely open. Insert the battery by following the diagram on the inside of the compartment door.
  • Release the latch and allow it to completely open.

  • Insert the battery by following the diagram on the inside of the compartment door.

  • Close the compartment door and firmly press on the latch until you hear a clicking sound.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Irene Huang

Membre depuis le 08/09/2014

439 Réputation

3 tutoriels rédigés

Équipe

CSU Fullerton, Team 1-3, Bruce Fall 2014 Membre de l'équipe CSU Fullerton, Team 1-3, Bruce Fall 2014

CSUF-BRUCE-F14S1G3

6 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 7

7 derniers jours : 45

30 derniers jours : 151

Total : 4,543