Introduction

A guide to opening up bObsweep and accessing internal parts such as: main circuit board, ground sensors, wall sensors, side brush motor, UV lamp, power switch, touch sensors, and wheels.

To reassemble bObi, refer to the closing guide. Closing bObi's Cover Post-Repair

Pièces

Aucune pièce nécessaire.

Remove bObi’s front wheel to access one of the screws holding bObi together. Make sure the wheel is turned closer to bObi's front touch sensors. Use your screwdriver for leverage, and the wheel will pop up and out.
  • Remove bObi’s front wheel to access one of the screws holding bObi together.

  • Make sure the wheel is turned closer to bObi's front touch sensors. Use your screwdriver for leverage, and the wheel will pop up and out.

  • Uninstall the larger screw that sits deeper in the wheel compartment.

Ajouter un commentaire

Remove bObi's dustbin. Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes. Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes.
  • Remove bObi's dustbin.

  • Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes.

Ajouter un commentaire

Lift the brush holder. To detach completely, unplug it from bObi. Remove the two screws on the dustbin contact point holder inside bObi. There are 4 screws beneath the main brushes. Uninstall these, and open bObi up to expose her main circuit board.
  • Lift the brush holder. To detach completely, unplug it from bObi.

  • Remove the two screws on the dustbin contact point holder inside bObi.

  • There are 4 screws beneath the main brushes. Uninstall these, and open bObi up to expose her main circuit board.

Ajouter un commentaire

Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed. Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed. Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed.
  • Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed.

Ajouter un commentaire

Conclusion

To reassemble bObi, refer to the closing guide. Closing bObi's Cover Post-Repair

Chelsea

Membre depuis le 24/09/2014

2 278 Réputation

31 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 144