Introduction

This guide will show the user how to disassemble the camera to reach the Flash Top Assembly. Once the Flash Top Assembly is reached, the user can replace it.

Pièces

Aucune pièce nécessaire.

Locate the memory card and battery card latch on the bottom of the camera.
  • Locate the memory card and battery card latch on the bottom of the camera.

  • Slide the latch to the open position.

Ajouter un commentaire

Open the battery latch, and slide the battery release lever to the right.
  • Open the battery latch, and slide the battery release lever to the right.

Ajouter un commentaire

Remove the battery from the camera.
  • Remove the battery from the camera.

Ajouter un commentaire

Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.
  • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

  • Use this screwdriver for all screws in the device.

Ajouter un commentaire

Remove the 3.15 mm screw on the left side of the camera.
  • Remove the 3.15 mm screw on the left side of the camera.

Ajouter un commentaire

Remove the left side casing. Remove the left side casing.
  • Remove the left side casing.

Ajouter un commentaire

Remove the two 3.15 mm screws on the right side of the camera.
  • Remove the two 3.15 mm screws on the right side of the camera.

Ajouter un commentaire

Remove the bottom right panel.
  • Remove the bottom right panel.

Ajouter un commentaire

Gently remove the back casing. Start at the bottom and carefully pry towards the top to get this piece free.
  • Gently remove the back casing.

  • Start at the bottom and carefully pry towards the top to get this piece free.

Ajouter un commentaire

Carefully pry the Flash Top Assembly away from the top. Carefully pry the Flash Top Assembly away from the top.
  • Carefully pry the Flash Top Assembly away from the top.

Ajouter un commentaire

Replace the Flash Top Assembly with a new one. Replace the Flash Top Assembly with a new one.
  • Replace the Flash Top Assembly with a new one.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Caleb Fink

Membre depuis le 11/10/2010

186 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 9-22, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 9-22, Regan Fall 2010

CPSU-REGAN-F10S9G22

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 3,506