Introduction

Use this guide to replace the back cover which houses the back panel buttons and LCD screen.

Pièces

Aucune pièce nécessaire.

Remove the following eleven screws securing the covers to the ZS3 Eleven 3 mm Phillips screws Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.
  • Remove the following eleven screws securing the covers to the ZS3

    • Eleven 3 mm Phillips screws

  • Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.

On some versions of this model, removing the back cover will suffice for this repair. The back cover is secured by only six screws.

Alex Levine - Réponse

Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown. Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.
  • Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown.

  • Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.

Ajouter un commentaire

Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit. Be sure you are opening the locking tab, not pulling against the socket mounted to the board.
  • Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit.

  • Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

Ajouter un commentaire

Remove the two LCD board ribbon cables out of their sockets.
  • Remove the two LCD board ribbon cables out of their sockets.

There are two ribbon cables: a wide one for the lcd display itself, and a thin one for the backlight. When reassembling, it is easy to reverse the polarity on the backlight cable, in which case the backlight will not work. Make a note of the polarity as you disassemble.

Alex Levine - Réponse

when I pried the small band's socket, the socket came off the board. What do I do now ? can I resolder it and where to ????

Karen Kornbau - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

Équipe

Cal Poly, Team 13-60, Johann Spring 2013 Membre de l'équipe Cal Poly, Team 13-60, Johann Spring 2013

CPSU-JOHANN-S13S13G60

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 627