Introduction

This guide provides the steps to remove the back cover. This process is necessary to access many of the components inside.

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

Ajouter un commentaire

Slide the latch to the right and then down to unlock it. Pull out the battery.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

Ajouter un commentaire

Flip the device upside down with the handle facing away from you.
  • Flip the device upside down with the handle facing away from you.

  • Open the optical drive bay by sliding its latch to the right.

  • Locate optical drive release mechanism on the bottom of the laptop.

Ajouter un commentaire

Slide the latch cover to the right.
  • Slide the latch cover to the right.

Ajouter un commentaire

Push the exposed switch to the left to eject the optical drive. Push the exposed switch to the left to eject the optical drive.
  • Push the exposed switch to the left to eject the optical drive.

Ajouter un commentaire

Begin by turning the laptop upside down with the handle towards you.
  • Begin by turning the laptop upside down with the handle towards you.

  • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

Ajouter un commentaire

Remove the panel and set it aside.
  • Remove the panel and set it aside.

  • Use a Phillips size 0 screwdriver to remove these 8 small screws.

Ajouter un commentaire

Use a Phillips size 1 screwdriver to remove the remaining 8 screws.
  • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

Ajouter un commentaire

Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive. Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.
  • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

Ajouter un commentaire

Be careful when lifting the cover as you may damage some connections.
  • Be careful when lifting the cover as you may damage some connections.

  • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

Ajouter un commentaire

Now the back cover should be off and you can access the inside of the casing.
  • Now the back cover should be off and you can access the inside of the casing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rohun Heesen

Membre depuis le 13/04/2010

330 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 27-93, Amido Spring 2010 Membre de l'équipe Cal Poly, Team 27-93, Amido Spring 2010

CPSU-AMIDO-S10S27G93

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 6

30 derniers jours : 29

Total : 8,849