Introduction

This guide will show you how to remove the wireless card from a Panasonic Toughbook CF-29

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

Ajouter un commentaire

Slide the latch to the right and then down to unlock it. Pull out the battery.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

Ajouter un commentaire

Begin by turning the laptop upside down with the handle towards you.
  • Begin by turning the laptop upside down with the handle towards you.

  • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

Ajouter un commentaire

Remove the panel and set it aside.
  • Remove the panel and set it aside.

  • Use a Phillips size 0 screwdriver to remove these 8 small screws.

Ajouter un commentaire

Use a Phillips size 1 screwdriver to remove the remaining 8 screws.
  • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

Ajouter un commentaire

Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive. Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.
  • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

Ajouter un commentaire

Be careful when lifting the cover as you may damage some connections.
  • Be careful when lifting the cover as you may damage some connections.

  • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

Ajouter un commentaire

Now the back cover should be off and you can access the inside of the casing.
  • Now the back cover should be off and you can access the inside of the casing.

Ajouter un commentaire

Remove the black and white wires attached to the wireless card by simply pulling up.
  • Remove the black and white wires attached to the wireless card by simply pulling up.

Ajouter un commentaire

Peel back the black cover to expose the clips holding in the wireless card.
  • Peel back the black cover to expose the clips holding in the wireless card.

Ajouter un commentaire

Using a pair of plastic opening tools, push the two metal tabs away from the card.
  • Using a pair of plastic opening tools, push the two metal tabs away from the card.

Ajouter un commentaire

The wireless card should now easily disengage from the motherboard. Pull the card horizontally away from you to remove it from its housing.
  • The wireless card should now easily disengage from the motherboard.

  • Pull the card horizontally away from you to remove it from its housing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Devon Augustus

Membre depuis le 12/04/2010

97 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 27-93, Amido Spring 2010 Membre de l'équipe Cal Poly, Team 27-93, Amido Spring 2010

CPSU-AMIDO-S10S27G93

4 membres

12 tutoriels rédigés

what about the heatsinks of the processors? You don't fix the contact surface to the cover?

michael - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 26

Total : 13,275