Philips Norelco BG2040 BodyGroom 7100 Motor Replacement

Introduction

This guide will show how to take out a broken motor, and replace it with a new one. You may need this if either the trimmer or shaver head on the Philips Norelco Bodygroom stop working due to motor malfunctions. It is also necessary for this guide to show how to disassemble and reassemble the trimmer in order to get to the motors. It is recommended to have the iFixit Pro Tech Toolkit since it will contain all tools necessary for this guide. Lastly, you will need to provide your own working motor to replace the broken one.

Ce dont vous avez besoin

Étape 1 LED Board

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement, LED Board: étape 1, image 1 de 2

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement, LED Board: étape 1, image 2 de 2

Place thumb behind trimming blade and push up to open.

Traduire

Étape 2

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement: étape 2, image 3 de 3

Remove two screws (M2 x 9.5) on metal plate with JIS 0 screwdriver bit.
Use spudger to pry off metal plate.
Slide up plastic housing to remove the trimmer.

Traduire

Étape 3

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement: étape 3, image 3 de 3

Slide chrome outer plastic towards removed trimmer.
Flip to the other side and repeat, sliding the chrome plastic towards removed trimmer.

Traduire

Étape 4

Remove two top screws (M2 x 6.9) with the JIS 00 screwdriver bit.
Remove two bottom screws (M2 x 6.9) with the same bit.

Traduire

Étape 5

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement: étape 5, image 3 de 3

Use spudger to pry off top of the battery cover. WARNING: fairly difficult, be aware significant amount of force required.
Use spudger to remove bottom of the battery cover, and remove it.

Traduire

Étape 6

Use a nylon spudger to pry out battery pack and the attached LED board.

Traduire

Étape 7

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement: étape 7, image 3 de 3

Unwrap electrical tape around the battery pack and LED board.
Desolder the LED board from the battery pack.
Solder the new LED board back to the connection to battery pack.

Traduire

Étape 8 Motor

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement, Motor: étape 8, image 1 de 3

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement, Motor: étape 8, image 2 de 3

Philips Norelco BG2040 BodyGroom 7100 Motor Replacement, Motor: étape 8, image 3 de 3

*Please note that you do not need to remove the LED board from the battery pack for this guide. Begin the following steps after removal of the entire battery pack.*
Using the spudger, unclip the plastic housing around white casing.
Remove one half of the black housing first, and then proceed to the next half.