Introduction

This guide will show you how to replace the circuit board for the Philips Sonicare 2 Series toothbrush. He is a link for a guide how to soldering which will be needed for this guide. Comment souder et dessouder des connexions

Remove brush on top of device.
  • Remove brush on top of device.

Ajouter un commentaire

Remove the 12 mm T8 Torx screw from the bottom of the toothbrush. After removing the screw, pry off the base with a plastic opening tool.
  • Remove the 12 mm T8 Torx screw from the bottom of the toothbrush. After removing the screw, pry off the base with a plastic opening tool.

Ajouter un commentaire

Remove the internal electronic mechanism from the housing by prying the red clips shown in the figure. This removes the charging port. Be very careful not to damage the charging port during this step.  Otherwise you will have to solder this part back to the device as shown in the second figure.
  • Remove the internal electronic mechanism from the housing by prying the red clips shown in the figure. This removes the charging port.

  • Be very careful not to damage the charging port during this step. Otherwise you will have to solder this part back to the device as shown in the second figure.

Ajouter un commentaire

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Next you will be able to remove the internal electronic mechanism as shown in the figure.
  • Next you will be able to remove the internal electronic mechanism as shown in the figure.

Ajouter un commentaire

Remove the white battery cover as shown in the figure.
  • Remove the white battery cover as shown in the figure.

Ajouter un commentaire

Remove the white circuit board cover as shown. This cover will require you to pry off the piece from the groves .
  • Remove the white circuit board cover as shown. This cover will require you to pry off the piece from the groves .

Ajouter un commentaire

Pry away the battery using an opening tool from the battery housing. This will break the circuit and avoid electric shock.
  • Pry away the battery using an opening tool from the battery housing. This will break the circuit and avoid electric shock.

Ajouter un commentaire

Desolder the circuit board from the motor as shown.
  • Desolder the circuit board from the motor as shown.

Ajouter un commentaire

Desolder the circuit board from the housing as shown to remove the board
  • Desolder the circuit board from the housing as shown to remove the board

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jonathan Jarvis

Membre depuis le 01/04/2016

452 Réputation

4 tutoriels rédigés

Équipe

IUPUI, Team S6-G2, Baechle Fall 2017 Membre de l'équipe IUPUI, Team S6-G2, Baechle Fall 2017

IUPUI-BAECHLE-F17S6G2

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 16

Total : 118