Introduction

This guide will show you how to locate and replace the fan in the PlayStation 2 Slimline.

Disconnect all cables from the console and flip the unit over to reveal its base.
  • Disconnect all cables from the console and flip the unit over to reveal its base.

Ajouter un commentaire

Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws. Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony. Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.
  • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

  • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

Ajouter un commentaire

Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver. Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver. Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.
  • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

Ajouter un commentaire

Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit. Note: You may use your hands for additional force to separate the two pieces of the outer shell. Note: You may use your hands for additional force to separate the two pieces of the outer shell.
  • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

  • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

Ajouter un commentaire

Locate the fan at the front, left section of the unit. Locate the fan at the front, left section of the unit.
  • Locate the fan at the front, left section of the unit.

Ajouter un commentaire

Peel off the sticker holding the power cords to the unit. Peel off the sticker holding the power cords to the unit.
  • Peel off the sticker holding the power cords to the unit.

Ajouter un commentaire

Lift the connector from the motherboard with a pair of tweezers using a firm, upward force. Lift the connector from the motherboard with a pair of tweezers using a firm, upward force.
  • Lift the connector from the motherboard with a pair of tweezers using a firm, upward force.

Ajouter un commentaire

Remove all three 1.6 mm screws fastening the fan to the unit using a #1 Phillips screwdriver. Gently lift and remove the fan from its compartment. Gently lift and remove the fan from its compartment.
  • Remove all three 1.6 mm screws fastening the fan to the unit using a #1 Phillips screwdriver.

  • Gently lift and remove the fan from its compartment.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Thomas Sullivan

Membre depuis le 23/10/2013

2 114 Réputation

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 14

30 derniers jours : 46

Total : 2,151