Introduction

In the event that the lens cover is not functioning properly, either permanently opened or closed, it is necessary to align it properly on its spring arm.

Pièces

Aucune pièce nécessaire.

Locate and remove the silver screws on each side of the camera. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.
  • Locate and remove the silver screws on each side of the camera.

  • Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.

Ajouter un commentaire

Then, carefully pry apart the front and back outer casing away from the internal components. Be aware of the ribbon wire that will disconnect when the casing is detached. Be aware of the ribbon wire that will disconnect when the casing is detached.
  • Then, carefully pry apart the front and back outer casing away from the internal components.

  • Be aware of the ribbon wire that will disconnect when the casing is detached.

Ajouter un commentaire

Place the internal electronics face-up. Look at the side with the flash turned towards you.
  • Place the internal electronics face-up. Look at the side with the flash turned towards you.

  • The lens cover is a small sheet of metal that rests directly infront of the lens when the camera is turned off.

  • Check to see if the spring action arm (what the yellow arrow is pointing to) is attached to the lens cover with the small knob in the corner (circled in yellow).

Ajouter un commentaire

If the arm is not attached (as shown in the previous), use tweezers to place the arm over the knob on the lens cover.
  • If the arm is not attached (as shown in the previous), use tweezers to place the arm over the knob on the lens cover.

  • Inside the yellow circle, the arm is in the correct position.

Ajouter un commentaire

Conclusion

Reassemble the casing by reversing steps 1 and 2.

Megan Milam

Membre depuis le 11/03/2013

28 Réputation

5 tutoriels rédigés

Équipe

Clemson, Team 12-4, Benson Spring 2013 Membre de l'équipe Clemson, Team 12-4, Benson Spring 2013

CLEM-BENSON-S13S12G4

3 membres

7 tutoriels rédigés

In Bild 3 ist der gelbe Kreis falsch gesetzt: der kleine Knopf ist unten links an der Blende, wie in Bild 4 positioniert. hr

Hubert Rieping - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 496