Danger
Potentiellement dangereux
Risque de blessure si cette procédure n'est pas suivie correctement. Faites preuve de prudence et suivez tous les avertissements.
Danger

Pièces

Aucune pièce nécessaire.

Disconnect the power supply cord from the outlet.
  • Disconnect the power supply cord from the outlet.

Ajouter un commentaire

Remove the eight screws holding the wood-patterned cover to the microwave frame. The first four screws are located on either side of the microwave front.
  • Remove the eight screws holding the wood-patterned cover to the microwave frame.

  • The first four screws are located on either side of the microwave front.

Ajouter un commentaire

Remove the additional four screws securing the wood-paneled case to the microwave frame. Remove the additional four screws securing the wood-paneled case to the microwave frame.
  • Remove the additional four screws securing the wood-paneled case to the microwave frame.

Ajouter un commentaire

Placing your hands on either side of the case, slide the case back gently until you feel it completely separate from the microwave frame. Lift the case upward slowly until the case is free of the microwave. Lift the case upward slowly until the case is free of the microwave.
  • Placing your hands on either side of the case, slide the case back gently until you feel it completely separate from the microwave frame.

  • Lift the case upward slowly until the case is free of the microwave.

Ajouter un commentaire

Locate the fan in the newly exposed interior. Try spinning the fan with your finger. If it spins freely, the fan is not jammed.
  • Locate the fan in the newly exposed interior.

  • Try spinning the fan with your finger. If it spins freely, the fan is not jammed.

  • If the fan does not spin freely, locate what is jamming the fan and remove it.

Ajouter un commentaire

If the fan is not jammed yet still does not work, check that there are no disconnected wires, especially to the fan.
  • If the fan is not jammed yet still does not work, check that there are no disconnected wires, especially to the fan.

  • In order to work properly, there should be two wires going in and out of the fan. If you are missing either of these wires, locate the loose wire/s and connect them.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Melanie

Membre depuis le 26/09/2012

59 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 2-12, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 2-12, Propen Fall 2012

CPSU-PROPEN-F12S2G12

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 1,065