Before disassembly, make sure that the device is unplugged.
  • Before disassembly, make sure that the device is unplugged.

  • Unscrew the two 17.83 mm black screws located on the handle.

Ajouter un commentaire

Separate the shell from the main component.
  • Separate the shell from the main component.

  • Make sure that the each piece is free from debris.

Ajouter un commentaire

Continue to pull the components apart. For reassembly, put the silver encasing on before the the black cover. For reassembly, put the silver encasing on before the the black cover.
  • Continue to pull the components apart.

  • For reassembly, put the silver encasing on before the the black cover.

Ajouter un commentaire

Locate the switches in the handle of the device.
  • Locate the switches in the handle of the device.

Ajouter un commentaire

Set the multimeter to 200 ACV.
  • Set the multimeter to 200 ACV.

Ajouter un commentaire

Bring the probes toward each switch to test for continuity.
  • Bring the probes toward each switch to test for continuity.

  • If the numbers on the multimeter continue to change, the circuit is closed and the switches are functioning.

  • If the meter stays at a finite number, the circuit is open and the switch needs to be replaced.

  • To replace faulty switch, cut the wires and solder the wires back on to the new switch.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jessica Leyva

Membre depuis le 18/09/2012

80 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 1-5, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-5, Propen Fall 2012

CPSU-PROPEN-F12S1G5

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 12

Total : 810