Before disassembly, make sure that the device is unplugged.
  • Before disassembly, make sure that the device is unplugged.

  • Unscrew the two 17.83 mm black screws located on the handle.

Ajouter un commentaire

Separate the shell from the main component.
  • Separate the shell from the main component.

  • Make sure that the each piece is free from debris.

Ajouter un commentaire

Continue to pull the components apart. For reassembly, put the silver encasing on before the the black cover. For reassembly, put the silver encasing on before the the black cover.
  • Continue to pull the components apart.

  • For reassembly, put the silver encasing on before the the black cover.

Ajouter un commentaire

Locate the thermal cutout under the coils of the heating element.
  • Locate the thermal cutout under the coils of the heating element.

Ajouter un commentaire

Test the thermal cutout for continuity using the multimeter.
  • Test the thermal cutout for continuity using the multimeter.

  • Make sure the multimeter is set to 200 ACV and bring the probes toward the thermal cutout.

  • If the numbers on the multimeter continue to change, the circuit is closed and properly functioning.

  • If the multimeter reads a consistent number, the circuit is opened and the thermal cutout needs to be replaced.

Ajouter un commentaire

To replace the thermal cutout, use the spudgers to extract the object.
  • To replace the thermal cutout, use the spudgers to extract the object.

  • To remove, wedge it back and forth until it comes free.

  • You do not need to take out the gold piece, only the thermal cutout.

Ajouter un commentaire

Replace the old thermal cutout with a new thermal cutout by snapping it into place.
  • Replace the old thermal cutout with a new thermal cutout by snapping it into place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jessica Leyva

Membre depuis le 18/09/2012

80 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 1-5, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-5, Propen Fall 2012

CPSU-PROPEN-F12S1G5

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 9

Total : 1,430