Introduction

This guide will show the steps to remove the outer case for the Ricoh Theta S. Be aware that any replacement of disassembly of the original product may void the manufacturer warranty.

Pièces

Aucune pièce nécessaire.

Wedge the spudger underneath the small plastic square located on the bottom of the device.
  • Wedge the spudger underneath the small plastic square located on the bottom of the device.

  • Move the spudger to remove the plastic cover.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Use a Phillips #00 screwdriver to remove the four 3-mm screws located on the bottom of the device. Use a Phillips #00 screwdriver to remove the four 3-mm screws located on the bottom of the device.
  • Use a Phillips #00 screwdriver to remove the four 3-mm screws located on the bottom of the device.

Ajouter un commentaire

Insert the plastic opening tool in between the panels shown. Apply pressure to unlatch the 9 spring clips located around the perimeter of the device. Lift the panel from the device.
  • Insert the plastic opening tool in between the panels shown.

  • Apply pressure to unlatch the 9 spring clips located around the perimeter of the device.

  • Lift the panel from the device.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Bradley Sutton

Membre depuis le 07/11/2017

401 Réputation

4 tutoriels rédigés

Équipe

IUPUI, Team S3-G1, Harley Fall 2017 Membre de l'équipe IUPUI, Team S3-G1, Harley Fall 2017

IUPUI-HARLEY-F17S3G1

3 membres

4 tutoriels rédigés

Where can find spare part case?

Thanks

Franco - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 8

30 derniers jours : 16

Total : 108