Introduction

If camera lens jams or breaks, this guide will help you replace it.

Remove the six external screws from the camera using a Phillips #0 screwdriver. After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera. Be careful, make sure you don't lose the screws.
  • Remove the six external screws from the camera using a Phillips #0 screwdriver.

  • After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera.

  • Be careful, make sure you don't lose the screws.

Ajouter un commentaire

Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery. Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.
  • Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.

Ajouter un commentaire

Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera. Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera. Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.
  • Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.

Ajouter un commentaire

Carefully squeeze the top right corner of the camera and pry off the external cover.
  • Carefully squeeze the top right corner of the camera and pry off the external cover.

  • If you hear a "cracking" sound. This is normal.

  • Continue to pull the external cover and it will come off cleanly.

  • Be cautious of the flash capacitor. It carries an electrical charge, that may give you an unpleasant shock.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Carefully pull off the back cover, parts behind the back of the case might fall out.
  • Carefully pull off the back cover, parts behind the back of the case might fall out.

Ajouter un commentaire

Remove the front cover, it comes off easily.
  • Remove the front cover, it comes off easily.

  • Buttons might fall out when you remove the front cover.

Ajouter un commentaire

Remove green tape from ribbon.
  • Remove green tape from ribbon.

Ajouter un commentaire

Remove four screws around lens. Remove four screws around lens.
  • Remove four screws around lens.

Ajouter un commentaire

Use spudger to remove ribbon connecting the circuit board from lens.
  • Use spudger to remove ribbon connecting the circuit board from lens.

Ajouter un commentaire

Remove lens from camera.
  • Remove lens from camera.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Adriel

Membre depuis le 15/04/2010

111 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 6-17, Maness Spring 2010 Membre de l'équipe Cal Poly, Team 6-17, Maness Spring 2010

CPSU-MANESS-S10S6G17

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 11

Total : 8,934