Introduction

The screen may become broken over time. This guide will assist in the replacement of the screen.

Pièces

Aucune pièce nécessaire.

Slide the latch on the back of the phone up.
  • Slide the latch on the back of the phone up.

Ajouter un commentaire

Remove the battery.
  • Remove the battery.

Ajouter un commentaire

After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.
  • After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.

Ajouter un commentaire

Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.
  • Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.

Ajouter un commentaire

With a #0 Phillips screwdriver remove the screw which you just uncovered.
  • With a #0 Phillips screwdriver remove the screw which you just uncovered.

Ajouter un commentaire

Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open. Then disconnect the small power connector near the top of the phone.
  • Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open.

  • Then disconnect the small power connector near the top of the phone.

Ajouter un commentaire

Gently pry up the ribbon-type connector with the spudger.
  • Gently pry up the ribbon-type connector with the spudger.

Ajouter un commentaire

Carefully pry the logic board from the case with the spudger.
  • Carefully pry the logic board from the case with the spudger.

Ajouter un commentaire

Once the logic board has been removed, peel the keypad up.
  • Once the logic board has been removed, peel the keypad up.

Ajouter un commentaire

When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing. When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.
  • When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.

Ajouter un commentaire

Remove screws with #0 Phillips screwdriver.
  • Remove screws with #0 Phillips screwdriver.

Ajouter un commentaire

Carefully pry apart the casing with the spudger tool.
  • Carefully pry apart the casing with the spudger tool.

Ajouter un commentaire

Use the spudger to carefully pry off the speaker.
  • Use the spudger to carefully pry off the speaker.

Ajouter un commentaire

Carefully pry off the ringer with the spudger.
  • Carefully pry off the ringer with the spudger.

Ajouter un commentaire

Carefully pry off the screen with the spudger.
  • Carefully pry off the screen with the spudger.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nathan Brink

Membre depuis le 11/04/2010

1 Réputation

8 tutoriels rédigés

Équipe

Cal Poly, Team 34-59, Forte Spring 2010 Membre de l'équipe Cal Poly, Team 34-59, Forte Spring 2010

CPSU-FORTE-S10S34G59

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 3,215