Pièces

Aucune pièce nécessaire.

Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
  • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

Ajouter un commentaire

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

Ajouter un commentaire

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Ajouter un commentaire

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Ajouter un commentaire

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Ajouter un commentaire

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Ajouter un commentaire

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Ajouter un commentaire

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. The three screws are shown on the diagram.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

Ajouter un commentaire

Remove the two screws from the plastic bar. The two screws are shown pictured.
  • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

Ajouter un commentaire

To remove the CD tray Remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

Ajouter un commentaire

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Ajouter un commentaire

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four screws are highlighted on the diagram.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

Ajouter un commentaire

Carefully remove the CD tray from circuit board.
  • Carefully remove the CD tray from circuit board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

sskyllin

Membre depuis le 18/10/2010

21 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 5-14, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 24

Total : 6,676