You will need: CR 2032 Battery Philips #0 screwdriver
  • You will need:

    • CR 2032 Battery

    • Philips #0 screwdriver

    • Something to pop the battery out, like a thin spudger, or a #2 slot screwdriver.

Ajouter un commentaire

Remove these four screws. They're all the same size. Remove these four screws. They're all the same size.
  • Remove these four screws. They're all the same size.

Ajouter un commentaire

Lift off the case back. Underneath, you'll see a sheet of plastic film. It should be possible to remove the battery without removing the film, if you're careful, but I didn't want to risk bending or tearing the plastic.
  • Lift off the case back.

  • Underneath, you'll see a sheet of plastic film. It should be possible to remove the battery without removing the film, if you're careful, but I didn't want to risk bending or tearing the plastic.

  • If you do take the plastic off, beware of maneuvering it over the three springs in the upper left, and the small prong that sticks out over the battery. You'll need to be sure to arrange the plastic carefully over these obstructions when re-assembling.

Ajouter un commentaire

Insert spudger or flat screwdriver in the notch indicated by the arrow, and lever out the battery.
  • Insert spudger or flat screwdriver in the notch indicated by the arrow, and lever out the battery.

  • The new battery should insert the same way the old one came out, and snap into place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Mark Boszko

Membre depuis le 02/02/2012

131 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 737