Solio Rocsta Charging Cable Replacement

Introduction

The Solio Rocsta's charging cable is the main connection for charging/using your device. In this guide, we will show you how to replace your charging cable if it no longer works or needs repairing.

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

Ce dont vous avez besoin

Étape 1 Charging Cable

Solio Rocsta Charging Cable Replacement, Charging Cable: étape 1, image 1 de 2

Solio Rocsta Charging Cable Replacement, Charging Cable: étape 1, image 2 de 2

Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

Traduire

Étape 2

Remove top cover.
Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire.

Traduire

Étape 3

Using the spudger, pry the battery off the back cover.

Traduire

Étape 4

Unscrew the 5.66 mm screws attaching the circuit board to the case.

Traduire

Étape 5

With the circuit board flipped, locate the battery connector.
Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

Traduire

Étape 6

With a Soldering Iron, desolder the four cables that connect the charging cable to the circuit board.
The power cable is a series of four cables. Make note of each cable placement for easy resoldering.
For more information on how to solder and desolder connections, please visit this guide.