Outils

Aucun outil requis.

Pièces

Unscrew the screws on the top of the radio.
  • Unscrew the screws on the top of the radio.

Ajouter un commentaire

Open the CD and cassette doors and remove the screws in the compartments. To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.
  • Open the CD and cassette doors and remove the screws in the compartments.

  • To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.

Ajouter un commentaire

Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.
  • Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.

Ajouter un commentaire

Remove the top of the radio enough to access the wires for removal.
  • Remove the top of the radio enough to access the wires for removal.

  • Do not forcefully remove the whole top piece of the radio! There will be wires connected to the top cover and circuit board.

Ajouter un commentaire

Remove all of the wires that are connected to both the circuit board and the underside of  the top of the radio by pulling them where they are connected
  • Remove all of the wires that are connected to both the circuit board and the underside of the top of the radio by pulling them where they are connected

  • This should include three sets of red and white wires, one set of white wires, one set of black wires, and two ribbon wires. Some cannot be disconnected from the top piece of the radio. Disconnect these plugs from the circuit board.

Ajouter un commentaire

Unscrew the screws in the circuit board.
  • Unscrew the screws in the circuit board.

Ajouter un commentaire

Unlodge the green headphone jack on the back of the circuit board by pulling on the back of the radio and lifting the circuit board up.
  • Unlodge the green headphone jack on the back of the circuit board by pulling on the back of the radio and lifting the circuit board up.

  • This may be a little difficult and don't pull to hard because the radio may crack.

Ajouter un commentaire

Lift the circuit board out of the radio.
  • Lift the circuit board out of the radio.

Ajouter un commentaire

Insert and align the new circuit board and screw it down.
  • Insert and align the new circuit board and screw it down.

Ajouter un commentaire

Reconnect the wires that were unplugged from the prerequisite steps.
  • Reconnect the wires that were unplugged from the prerequisite steps.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Ian Nussman

Membre depuis le 25/10/2013

776 Réputation

6 tutoriels rédigés

Équipe

University of Maryland, Team 2-5, Gulbrandsen Fall 2013 Membre de l'équipe University of Maryland, Team 2-5, Gulbrandsen Fall 2013

UMD-GULBRANDSEN-F13S2G5

2 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 9

30 derniers jours : 101

Total : 2,612