Introduction

Replace a broken fuse on the TRS-80 Color Computer's power supply.

Flip the computer over.
  • Flip the computer over.

  • Remove the two 24.1mm Phillips screws near the front of the case.

  • Remove the five 33.0 mm Phillips screws towards the back of the case.

Ajouter un commentaire

Carefully flip the computer right side up. Lift off the top half of the case.
  • Carefully flip the computer right side up.

  • Lift off the top half of the case.

Ajouter un commentaire

Near the motherboard, gently pull the keyboard ribbon cable until it becomes free. Lift the keyboard out of the case.
  • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

  • Lift the keyboard out of the case.

Ajouter un commentaire

Remove the nine 15.24 mm Phillips screws securing the motherboard in place. When removing the spring door, make sure to keep the door closed. When removing the spring door, make sure to keep the door closed.
  • Remove the nine 15.24 mm Phillips screws securing the motherboard in place.

  • When removing the spring door, make sure to keep the door closed.

Ajouter un commentaire

Remove the 5 jumper cables from the motherboard. Once the jumper cables lift the motherboard up gently; it should lift out easily. Once the jumper cables lift the motherboard up gently; it should lift out easily.
  • Remove the 5 jumper cables from the motherboard.

  • Once the jumper cables lift the motherboard up gently; it should lift out easily.

Ajouter un commentaire

Remove the two 40.6mm Philips screws securing the TRS-80 transformer. Remove the two 40.6mm Philips screws securing the TRS-80 transformer.
  • Remove the two 40.6mm Philips screws securing the TRS-80 transformer.

Ajouter un commentaire

Remove the power cable jumpers from the power supply. Remove the power cable jumpers from the power supply. Remove the power cable jumpers from the power supply.
  • Remove the power cable jumpers from the power supply.

Ajouter un commentaire

Gently peel back the protective film on the top of the transformer.
  • Gently peel back the protective film on the top of the transformer.

Ajouter un commentaire

Locate the two points the fuse is soldered into the circuit board. Using a soldering iron and soldering wick, desolder and remove the fuse. Place the new fuse into the location of the old one, and solder it in place.
  • Locate the two points the fuse is soldered into the circuit board.

  • Using a soldering iron and soldering wick, desolder and remove the fuse.

  • Place the new fuse into the location of the old one, and solder it in place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Christopher Paige

Membre depuis le 21/01/2011

495 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 11-24, Maness Winter 2011 Membre de l'équipe Cal Poly, Team 11-24, Maness Winter 2011

CPSU-MANESS-W11S11G24

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 5

Total : 2,039