Introduction

Use this guide to remove the screen and motherboard in the TomTom XL. Removing the screen is necessary to access the XL's interior components.

Slip a small plastic opening tool underneath the screen bezel, gently sliding it around the inside edge.
  • Slip a small plastic opening tool underneath the screen bezel, gently sliding it around the inside edge.

  • Starting at the corners, carefully pry up the screen bezel.

Ajouter un commentaire

Remove the four Phillips #00 screws around the edge of the screen.
  • Remove the four Phillips #00 screws around the edge of the screen.

Ajouter un commentaire

Slide a small plastic opening tool under the top portion of the metal frame and gently lift it up. Slide the plastic opening tool around the inner edge of the metal frame until it feels loose. It may take some time to release the frame from the housing. Some force may be necessary—but be careful not to bend the frame's fragile interior bracket.
  • Slide a small plastic opening tool under the top portion of the metal frame and gently lift it up.

  • Slide the plastic opening tool around the inner edge of the metal frame until it feels loose.

    • It may take some time to release the frame from the housing. Some force may be necessary—but be careful not to bend the frame's fragile interior bracket.

  • Remove the frame from the housing.

Ajouter un commentaire

Lifting from the upper edge of the screen, tilt the screen away from the device. Tilt the screen slowly. Flipping the screen up too quickly may damage the display cable.
  • Lifting from the upper edge of the screen, tilt the screen away from the device.

  • Tilt the screen slowly. Flipping the screen up too quickly may damage the display cable.

Ajouter un commentaire

Remove the three Phillips #00 screws connecting the motherboard to the plastic housing: Two Phillips #00 screws are located at the bottom of the first picture.
  • Remove the three Phillips #00 screws connecting the motherboard to the plastic housing:

    • Two Phillips #00 screws are located at the bottom of the first picture.

    • The third screw is hidden under the orange ribbon cable, near the screen.

      • You may have to carefully lift the screen in order to reach this screw.

Ajouter un commentaire

Flip the screen and motherboard over. Gripping the plastic casing, disconnect the battery cable connector from the motherboard.
  • Flip the screen and motherboard over.

  • Gripping the plastic casing, disconnect the battery cable connector from the motherboard.

  • Disconnect the speaker cable connector from the motherboard.

  • Remove the motherboard and screen from the housing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Adam Johnson

Membre depuis le 21/04/2010

119 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 33-84, Johann Spring 2010 Membre de l'équipe Cal Poly, Team 33-84, Johann Spring 2010

CPSU-JOHANN-S10S33G84

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 10

Total : 8,583