Introduction

The optical drive reads the CD/DVD when inserted into the laptop. It is not unusual for the optical drive to go stop working or malfunction as there are numerous moving parts. This device is designed to be easily replaced in the case it does malfunction.

Pièces

Aucune pièce nécessaire.

Make sure the battery lock switch is switched to the unlocked position. The battery is unlocked when the battery lock switch is slid to the side with an image of an unlocked lock. The battery is unlocked when the battery lock switch is slid to the side with an image of an unlocked lock.
  • Make sure the battery lock switch is switched to the unlocked position.

    • The battery is unlocked when the battery lock switch is slid to the side with an image of an unlocked lock.

Ajouter un commentaire

Slide the battery release switch to the left. The switch is spring loaded, so you must hold the switch in place while removing the battery.
  • Slide the battery release switch to the left.

  • The switch is spring loaded, so you must hold the switch in place while removing the battery.

Ajouter un commentaire

Using a finger, lift up the battery. The battery release switch must be held in place.
  • Using a finger, lift up the battery.

  • The battery release switch must be held in place.

Ajouter un commentaire

Remove the two screws holding the hard drive panel down. These screw are permanently fastened to the panel; they are designed to be removed only partially. These screw are permanently fastened to the panel; they are designed to be removed only partially.
  • Remove the two screws holding the hard drive panel down.

  • These screw are permanently fastened to the panel; they are designed to be removed only partially.

Ajouter un commentaire

Use a finger to lift up on the tab and remove the panel.
  • Use a finger to lift up on the tab and remove the panel.

Ajouter un commentaire

Remove the screw that holds in place the optical drive. One 4.6 mm Phillips screw.
  • Remove the screw that holds in place the optical drive.

    • One 4.6 mm Phillips screw.

Ajouter un commentaire

Locate the small rectangular hole and insert the spudger. Gently slide the metal flange to the right to dislodge the optical drive.
  • Locate the small rectangular hole and insert the spudger.

  • Gently slide the metal flange to the right to dislodge the optical drive.

Ajouter un commentaire

The optical drive will become partially exposed.
  • The optical drive will become partially exposed.

Ajouter un commentaire

Pull the optical drive to remove it from the computer body. Pull the optical drive to remove it from the computer body.
  • Pull the optical drive to remove it from the computer body.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Stephen Sippel

Membre depuis le 16/04/2013

143 Réputation

9 tutoriels rédigés

Équipe

Cal Poly, Team 21-54, Johann Spring 2013 Membre de l'équipe Cal Poly, Team 21-54, Johann Spring 2013

CPSU-JOHANN-S13S21G54

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 646