Introduction

The circuit board is home to many of the smaller parts of the Verizon M1424WR. These parts are soldered on to the circuit board, so in order to access them, you will need to remove the circuit board from the casing.

This router will have to be reauthenitcated with Verizon if you replace any WAN hardware or the whole board. Your new MAC address will not be approved.

Pièces

Aucune pièce nécessaire.

Flip the device so that the bottom is facing up.
  • Flip the device so that the bottom is facing up.

Ajouter un commentaire

Insert the plastic-opening tool under the silver labeled casing. Carefully pry at different intervals around the silver labeled casing to separate the silver casing from the top and bottom casing. Carefully pry at different intervals around the silver labeled casing to separate the silver casing from the top and bottom casing.
  • Insert the plastic-opening tool under the silver labeled casing.

  • Carefully pry at different intervals around the silver labeled casing to separate the silver casing from the top and bottom casing.

Ajouter un commentaire

Unscrew the five 10-mm screws on the bottom of the router using a Phillips #0 screwdriver. Unscrew the five 10-mm screws on the bottom of the router using a Phillips #0 screwdriver.
  • Unscrew the five 10-mm screws on the bottom of the router using a Phillips #0 screwdriver.

Ajouter un commentaire

Use a plastic-opening tool and pry the top casing from the bottom casing to expose the circuit board in the bottom half of the device. Use a plastic-opening tool and pry the top casing from the bottom casing to expose the circuit board in the bottom half of the device.
  • Use a plastic-opening tool and pry the top casing from the bottom casing to expose the circuit board in the bottom half of the device.

Ajouter un commentaire

Locate the two 10-mm screws on either side of the circuit board. Unscrew the two 10-mm screws using a Phillips #0 screwdriver. Keep track of the red rubber washer you remove from underneath one of the screws.
  • Locate the two 10-mm screws on either side of the circuit board.

  • Unscrew the two 10-mm screws using a Phillips #0 screwdriver.

  • Keep track of the red rubber washer you remove from underneath one of the screws.

Ajouter un commentaire

Lift the front of the circuit board up from the bottom casing.
  • Lift the front of the circuit board up from the bottom casing.

Ajouter un commentaire

Pull the circuit board towards you until it is separate from the bottom casing.
  • Pull the circuit board towards you until it is separate from the bottom casing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jeffrey Fox

Membre depuis le 17/09/2014

305 Réputation

3 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 7

Total : 261