Réparez vos affaires Communauté Boutique

Zoomer Meowzies Back Button Contact Replacement

Introduction

The button on the device's back may sometimes become damaged or dirty and therefore need replacement. This guide will go over how to access the back button's contact in order to clean or replace.

Ce dont vous avez besoin

  1. Zoomer Meowzies Back Button Contact Replacement, Legs: étape 1, image 1 de 3 Zoomer Meowzies Back Button Contact Replacement, Legs: étape 1, image 2 de 3 Zoomer Meowzies Back Button Contact Replacement, Legs: étape 1, image 3 de 3

    • Using the Triangle driver remove the four 7.5 mm screws.

    • The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

    Traduire

  2. Zoomer Meowzies Back Button Contact Replacement: étape 2, image 1 de 2 Zoomer Meowzies Back Button Contact Replacement: étape 2, image 2 de 2

    • Turn the device so that the the device is on its side.

    • Hold the back and belly on the device and gently pull apart.

    • Pulling with too much force might damage a few cables inside, so caution is needed.

    Traduire

  4. Zoomer Meowzies Back Button Contact Replacement: étape 3, image 1 de 3 Zoomer Meowzies Back Button Contact Replacement: étape 3, image 2 de 3 Zoomer Meowzies Back Button Contact Replacement: étape 3, image 3 de 3

    • With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

    Traduire

  5. Zoomer Meowzies Back Button Contact Replacement, Back Button Contact Point: étape 4, image 1 de 3 Zoomer Meowzies Back Button Contact Replacement, Back Button Contact Point: étape 4, image 2 de 3 Zoomer Meowzies Back Button Contact Replacement, Back Button Contact Point: étape 4, image 3 de 3

    • Locate the gray rubber contact in the middle of the bottom half of the device. Using the spudger, lift one corner of the contact until it pops loose.

    • Grab the contact and gently pull until the other side detaches.

    • When replacing the contact pad, use the narrow leads on the pad to pull it into place by twisting around the tips of the tweezers.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 2 autres contributeurs

Mitchell Gentry

Membre depuis le 02/14/18

675 Réputation

6 tutoriels rédigés

Badges: 8

+ 5 badges supplémentaires

Équipe

USF Tampa, Team S6-G2, Eyestone Spring 2018 Membre de l'équipe USF Tampa, Team S6-G2, Eyestone Spring 2018

USFT-EYESTONE-S18S6G2

3 membres

16 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 224