Introduction

The step-by-step guide for removing bObi's cover and screen. For help putting bObi back together, refer to: Closing bObi's Cover Post-Repair

Outils

Aucun outil requis.

Pièces

Aucune pièce nécessaire.

Remove bObi’s front wheel to access one of the screws holding bObi together. Make sure the wheel is turned closer to bObi's front touch sensors. Use your screwdriver for leverage, and the wheel will pop up and out.
  • Remove bObi’s front wheel to access one of the screws holding bObi together.

  • Make sure the wheel is turned closer to bObi's front touch sensors. Use your screwdriver for leverage, and the wheel will pop up and out.

  • Uninstall the larger screw that sits deeper in the wheel compartment.

Ajouter un commentaire

Remove bObi's dustbin. Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes. Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes.
  • Remove bObi's dustbin.

  • Uninstall the 2 screws close to the bin and 2 smaller screws above her main brushes.

Ajouter un commentaire

Lift the brush holder. To detach completely, unplug it from bObi. Remove the two screws on the dustbin contact point holder inside bObi. There are 4 screws beneath the main brushes. Uninstall these, and open bObi up to expose her main circuit board.
  • Lift the brush holder. To detach completely, unplug it from bObi.

  • Remove the two screws on the dustbin contact point holder inside bObi.

  • There are 4 screws beneath the main brushes. Uninstall these, and open bObi up to expose her main circuit board.

Ajouter un commentaire

Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed. Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed. Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed.
  • Detach the two circuit plugs connecting bObi's cover to the main board and the cover will be completely removed.

Ajouter un commentaire

Remove the four screws that secure bObi's screen and lift the whole piece out. Put the replacement screen in the open space.
  • Remove the four screws that secure bObi's screen and lift the whole piece out.

  • Put the replacement screen in the open space.

Ajouter un commentaire

Re-install all four screws. For a tutorial on closing bObi, see: Closing bObi's Cover Post-Repair

Ajouter un commentaire

Conclusion

To reassemble your device, follow the guide for closing bObi, found here: Closing bObi's Cover Post-Repair

Chelsea

Membre depuis le 24/09/2014

2 278 Réputation

31 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 74