Introduction

Remove bottom housing to reveal the inside of the iMac.

Pièces

Aucune pièce nécessaire.

Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

Ajouter un commentaire

Loosen the four Phillips #0 screws.
  • Loosen the four Phillips #0 screws.

Ajouter un commentaire

Carefully remove the base access panel.
  • Carefully remove the base access panel.

Ajouter un commentaire

Remove the four 25mm T-15 screws. Remove the four 25mm T-15 screws.
  • Remove the four 25mm T-15 screws.

Ajouter un commentaire

Open the housing plate. Be gentle with the wires still connected to the logic board  so as not to ruin the cables.
  • Open the housing plate.

  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Justin

Membre depuis le 05/10/2011

235 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 21-22, Maness Fall 2011 Membre de l'équipe Cal Poly, Team 21-22, Maness Fall 2011

CPSU-MANESS-F11S21G22

4 membres

13 tutoriels rédigés

If you do this - don't you still need to apply a fresh coat of thermal paste to the exposed ends of the two heat-sink posts (that separate when you open a G4 flatpanel this far) - my understanding was that the machine would overheat and you'd be left with didley squat!!

Gregg :O)

amicuset - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 1,563